Σελίδα 10 από 14

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μαρ 23, 2016 11:56 pm
από biomecanoid

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Δευ Απρ 04, 2016 4:54 pm
από biomecanoid

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τρί Απρ 05, 2016 1:58 pm
από biomecanoid

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Απρ 06, 2016 2:47 pm
από biomecanoid

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Απρ 06, 2016 3:28 pm
από biomecanoid
H γνώμη ενός αεροναυπηγού για το Ranger:


Looking at the pictures of the model I can find on the net, the configuration is just poor. The high wing/thrust and the low tail is ALWAYS going to make for large trim changes with power AND speed.

Two things are happening.

1) unless you can make the thrustline point right thru the vertical CG of the aircraft it will always pitch down with throttle application, though as you have already found, you can reduce that with a little shimming on the bottom of the motor. Place the battery in the model as you normally would and lay the model on its side (one wing up, the other down) and find the vertical CG. if it is still pretty low on the fuselage (probably due the battery and the landing gear as the foam does not weigh much, unless you can raise the CG with the battery, not much you can do there except continue to shim the motor. it might look funny, but it will help and still fly the model.

2) the horizontal tail being low, with the wing high (like a Cessna 150 or 172) puts it in the downwash of the wing. This downwash angle changes with speed and if the model is "trimmed" for say a cruise throttle position, then any other throttle/speed position would either reduce or increase this downwash causing the model to pitch in either direction (up at slower speeds, down at higher speeds)

Unfortunately there will be no "tail" incidence position with a model configured this way that will be happy at all speeds. Time for a gyro.

Now, had the put the tail on the same level (plane) as the wing, things would have been much different. Trim changes with throttle/speed would have been less noticeable!

Hope this helps!


εν συντομία λέει πως το πρόβλημα που έχει στο pitch το αεροπλάνο θα μπορούσε να διορθωθεί άμα το horizontal stabilizer ήταν στο ίδιο επίπεδο με το φτερό.

Σαν την παρακάτω εικόνα:

http://gloimg.gearbest.com/gb/2015/201507/goods-img/1437323222296-P-2820612.jpg

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Απρ 20, 2016 5:41 pm
από biomecanoid

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τρί Μάιος 03, 2016 8:45 pm
από biomecanoid
Στην photo φαίνεται ποσο μεγάλη γωνια χρειάζεται το Ranger για να αρχίζει να πετάει καλά.

Οι stock βίδες επιτρέπουν μονο 2 ροδέλες άρα τώρα θέλουμε πιο μεγάλες μακριές βίδες, που θα βρω βίδες ?

Εικόναhttp://s32.postimg.org/j9spw6qht/Motor_Mount.jpg

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 8:36 am
από Apnos
Καλημέρα,

Τι βίδες χρειάζεσαι; (βάλε μια φωτό)

Αν δεν βρεις σε χρωματοπωλείο της γειτονιάς σου, πήγαινε μια βόλτα στο http://www.kentrovidas.gr
.

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 10:39 am
από Αντώνης Κριτζάς
.......στο κέντρο μπορείς να βρείς στον Ρέππα

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 10:50 am
από biomecanoid
Επίσης για όσους παρακολουθούν το θέμα το support τις Volantex μου είπε πως για να μην βουτάει το αεροπλάνο όταν πατάς "γκάζι" εκτος από την γωνια του μοτέρ μπορώ να αυξήσω και την γωνια του φτερού ( angle of attack )

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 11:23 am
από biomecanoid
Αυτές είναι οι βίδες του μοτέρ. Θέλω βίδες με το ίδιο σπείρωμα, ίδιο πάχος, αλλα μακρύτερες

Εικόναhttp://s32.postimg.org/fntunzd7l/IMG_4450.jpg


Εικόναhttp://s32.postimg.org/j1kxd1h9d/IMG_4453.jpg

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 12:27 pm
από Αντώνης Κριτζάς
Δοκιμάστηκε στον αέρα με τις δύο ροδέλες?

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 12:32 pm
από biomecanoid
Ναι και δεν ήταν αρκετό, η γωνια του μοτέρ που χρειάζεται είναι πολύ σχεδόν υπερβολική τόσο που χρειάζεται να κοπει το πάνω μέρος τις βάσης του μοτέρ γιατί θα εμποδίζει.

Επίσης η Volantex είπε πως εκτος από το μοτέρ πρέπει να αυξήσω και την γωνια του φτερού.

Ετσι ίσως άμα πειράξω και τα 2 από λίγο να μην χρειαστεί να κόψω την βάση του μοτέρ.

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 1:13 pm
από Αντώνης Κριτζάς
Η angle of attack στο μοντέλο σου αλλάζει πολύ εύκολα οπότε μπορεί να δοκιμαστεί άμεσα στο πεδίο μέχρι να βρεθεί το σωστό σημείο Η αύξηση της γωνίας θα το βοηθήσει πολύ και στην προσγείωση

Απάντηση: Volantex Ranger - Build Log

Δημοσιεύτηκε: Τετ Μάιος 04, 2016 3:34 pm
από biomecanoid
Πήρα βίδες αλλα άμα βάλεις παραπάνω από 2 ροδέλες το μοτέρ ακουμπάει στην οροφή τις βάσης οποτε άκυρο, άμα είναι να μεγαλώσει η γωνια ακόμα πρέπει να κοπει η βάση